GETTING NAVCODER TO WORK WITH INPA USB SERIAL

Ive used INPA before with another laptop and I know the two dots should go balck to show its connected. The two dots at the top, One for battery and the other for ignition stay blank. Interface is fully compatible with the OBD2 communication standard. I bought a diagnostic laptop with Navcoder INPA etc on. The interface supports all models from 1996 to 2006. It's enough to use any computer with a USB connector. The ibus interface is the necessayr hardware interface to convert the electrical signal of the BMW ibus into good old RS232 for the laptop. I work with programs such as INPA, EDIABAS, NCS EXPERT, DIS, TIS, SSS Progman. To use NavCoder you need a laptop with Windows (anything from Windows 2000 to Windows 7 it may still work on Win95, but I cannot test it on Win95 any more) and an ibus interface.

This interface is one of the most advanced devices for diagnosing BMW cars. All I was able to do was verify Country: ECE. Interface is fully compatible with OBD2 communication standard. Bugger, Yea, I tried standard BMW tools Progman, DIS, and INPA.

GETTING NAVCODER TO WORK WITH INPA USB SERIAL

Since both ELM327 and K DCan cables are doing the same job (uart serial to usb) as far as I know, I guess there should be a way to convert them to each other. As a result INPA 2K its good solution to near home garage and professional workshops. I have an elm327 20 pin cable(uart) to usb interface,but it doesnt work with INPA that is a BMW diagnostic software, I wonder if I could manage to use it as a D+K Can with some sort of minor changes. This device supporting double K-Line thanks this solution we donвЂ™t have any problems with connection. We are offering POLISH interface INPA 2K for BMW with switch between two K line.

Getting navcoder to work with inpa usb